Skip to main content
U.S. flag

This is an original und secure website

Circumference Bodyfat Calculator

years
kg
cm
cm
cm
cm

The following calculator gives you an estimate of your % bodyfat and lean body mass based on your weight, height, age and simple tape measurements (i.e. anthropometric measurements). Skin-fold measurements alone tend to underestimate body fat percentage in the obese and very lean (particularly with low hydration levels). The following calculator is based on equations which are useful for people in these groups as well as people with loose skin after very large weight loses. It is generally accurate to within a few percent. Anecdotally, it has also proven to be reasonably accurate with drug-free, genetically typical bodybuilders.

  • Age – your age in years
  • Height – your height without shoes
  • Waist size – measure around your waist at your navel and also at the point midway between your navel and the bottom of your sternum, and take the average of these two measurements – that is your “Waist” measurement. Stand tall, but do not deliberately suck in your stomach or the estimation will be wrong.
  • Iliac – measure around where your upper pelvic bones protrude the most (you can feel for them on either side of your waist/hips)
  • Hips – measure around the hips at the maximum protrusion of the buttocks

How to measure the body fat percentage?

Undoubtedly, determining body fat percentage is not an easy task! A weight lifter and an obese person may have the same weight, but their body fat percentages are different. Remember, weight alone does not tell you how much muscle or fat you have.

Read this post to learn more about different methods for determining your body fat percentage.

Tape measure:

The easiest and most common method for measuring body fat percentage is to use a soft tape measure. You can purchase body fat measuring tapes in the market. For this method, a person should know his height in inches.

For men:

If you are a man, then you should measure the circumference of your neck and abdomen. Make sure that you measure the largest part of both the areas. Also, the task will be easier if you have a friend or family member help you.

To find the body fat percentage, you just need to subtract the value for the neck from the value for the abdomen to get the value for the circumference.

For women:

If you are a woman, you will need to measure the circumference of your natural waist, neck and hips. Again, you will need to measure each area at its widest point. Ask your friend or a family member for help.

7 Ways to Measure Body Fat

There are many ways to estimate body fat. These methods use a wide variety of technologies, ranging from very simple (a tape measure) to very complicated (three-dimensional laser scanning technology. Each method has pros and cons and different levels of accuracy. Here is a quick review of those major technologies.

Skinfold Calipers

One of the most readily accessible ways to estimate body fat is to measure the physical thickness of the adipose (fat) layer directly under the skin. This layer is known as the subcutaneous fat layer. This method relies on precisely built and calibrated calipers that measure skin thickness in millimeters. While easy to perform, this method requires a substantial amount of training and has a pretty high error rate, with up to 10-15% error rates reported in some studies. As such, it is difficult to be certain of changes of <5% of body fat.

Body Circumference

Another very accessible and easy to perform method of estimating body composition is through measuring body circumference. More specifically things such as waist-to-hip ratios, waist-to-height ratios, and neck circumferences are ways to estimate body composition. There are good data to show how well different measures correlate to body fat percentages. Interestingly, waist to weight ratio appears to be the most accurate.

Hydrostatic Weighing

Hydrostatic weighing, also known as underwater weighing, is one of the more accurate forms of body composition assessment with error rates being between 2-5% for most apparatuses. However, this approach is expensive and requires very specialized equipment and training. For most people, this form of body composition assessment is impractical.

Bioelectrical Impedance

Bioelectrical impedance analysis, often referred to as BIA, utilizes electrical currents to assess body composition based on how electrical currents flow through the body. This method is very readily available as it can be put into handheld devices and even at home digital weight scales. However, many of the low-cost commercial models are imprecise with large error rates (greater than 10%). Research grade devices can have error rates as low as 5%.

Air-Displacement Plethysmography

Air-displacement plethysmography utilizes a similar principle as hydrostatic weighing, displacement. However, instead of displacing water, this method displaces air. It is roughly similar in terms of accuracy as hydrostatic weighing (hydrostatic weighing is slightly more accurate) but is substantially cheaper and easier to perform. The Bod Pod® is the most used device.

3D Body Scan

A new, emerging technology that is becoming more readily available are three-dimensional (3D) body scans. These technologies utilize laser capture technology to measure anthropometrics and estimate body composition. These technologies show relatively similar accuracy to other measures such as bioelectrical impedance, hydrostatic weighing, and air-displacement plethysmography with error rates between 3-10% depending on the instrument used.

Dual Energy X-ray Absorptiometry

Dual Energy X-ray Absorptiometry, commonly referred to as DEXA (DEXA) utilizes specialized machines that have different types of X-rays which can measure differences in density of tissue. This approach requires very specialized equipment and training, and some-states require licensure to use DEXA technology due to the radiographic nature of the equipment. While often believed to be the most accurate method of estimating body fat percentage, DEXA is roughly equal to air-displacement plethysmography, hydrostatic weighing, and 3D body scanning technology.

Importend Notes and Disclaimer

 

Caveats and Recommendations: This calculator is NOT intended to diagnose illness or be used as a substitute for medical advice or treatment. Some models provide predictive outcomes which may not be accurate. Please consult a medical professional for any medical treatment or diagnosis advice.

 

Note: This calculator is presented for your own personal use and is to be used as a guide only. Medical and other decisions should NOT be based on the results of this calculator. Although this calculator has been tested, we cannot guarantee the accuracy of its calculations or results.

 

Disclaimer: This calculator is provided without warranty and CANNOT be used to diagnose or treat any disease or condition.

In 51 U.S. states are published

1996 Companies
807 Counties
1391 Cities

The 5 newest Companies

New Haven Postal Employees CU

27 Masonic St, New London, CT 06320

Patelco Credit Union

1300 E Bidwell St Suite 155, Folsom, CA 95630

Credit Union of Texas

7801 Coit Rd, Plano, TX 75024

CBCS Inc

2 Executive Park Dr # 14, Bedford, NH 03110

Other Companies

Paducah Federal Credit Union

Op Box 95, Fancy Farm, KY 42039

Market USA Federal Credit Union

8871 Gorman Rd #100, Laurel, MD 20723

Scient Federal Credit Union

60 Colver Ave, Groton, CT 06340

Asakon Federal CU

12842 S Straits Hwy, Wolverine, MI 49799

Grow Financial Federal Credit Union: St. Petersburg Store

7301 Dr M.L.K. Jr St N, St. Petersburg, FL 33702